3037 TOWERS LOWER SECTION 3,0m 180

Product description:

3037 is the Lower pivoting section 3 m for TELEVES towers 180-series. For joining sections they feature couplings to be threaded.
Made of galvanized steel and bi-chromate coating, are supplied in two types of finishing: RPR or polyester painting. This model allows heights up to 26,5 m, depending on the environmental conditions.
Based on a new concept of design and manufacturing, which results in a considerable improvement in its torsional rigidity. All the effort in engineering provides the installer a bigger ease of handling and assembly, as well as a greater resistance of the tower at different heights, thanks to the new distribution of its lattice.

WARNING: Trestle-tower installations should only be calculated and constructed by specialised professionals as these fall under their responsibility; the mounting instructions provided in this technical sheet are intended for information only, and the data given does not, in any way, affect the responsibility of the manufacturer who only guarantees his own products, provided that they are used under normal conditions. It will be necessary to conduct a project to install the tower for each specific site, which should take into account both the individual stresses and the recalculation of foundations in accordance with the relevant geotechnical study. The towers will be assembled by competent personnel and skilled in climbing, using all means of protection required to safeguard the security in vertical works. Remenber that international legislation requires for any structure higher than 3m a climber safety device. The use of Televes tower sections with non-Televes products may cause tower failure and even personal injury. Televes and Edision are not responsible of the misuse of these products.



Technical features:

- LOWER PIVOTING section, 3m. tower 180
- Material: (1) Steel ST 37-2, O 20 x 2 mm thickness. Re min. 235 N/m2 - Rn min. 360/510 N/m2 (2) Steel S 275 JR, O 6 mm Re min. 275 N/m2 - Rn min. 410/560 N/m2 (3) Steel F626 (S 235), 10 mm thickness plate. Re min. 235 N/m2 - Rn min. 340 N/m2
- Finishing: Galvanised 10 ± 1μm thickness + Bichromated + R.P.R. (Reactive Protection Process)
- Surface facing the wind: 0,27 m2 x 1,2 coef. = 0,273 m2
- Change of the lattice's structure which increases strength and torsional stiffness.
- New detachable racord that allows a better protection of the section against rusting, thus increasing the durability of the tower.
- Made of steel with shiny zinc and bi-chrome coating and RPR.
- New fitting system that facilitates the insertion between sections.
- New metric of fine pitch.
- 2-year warranty